Forum

Welcome to the Panbo Marine Technology Forums.

Jonathan Udell
Jonathan Udell
@jonudell
Active Member
Joined: September 18, 2018 9:53 pm
Last seen: September 25, 2023 9:23 pm
Topics: 0 / Replies: 9
Reply
RE: New Install Simrad AP24 Autopilot- Banging my head

A bad element (like a bad AC42) can absolutely trash a backbone. If a N2 component on the backbone has a shorted/damaged communication board once it ...

7 months ago
Reply
RE: Simrad AIS 400 PWR/0183 connector

Jeff - I'm almost certain that I have a NAIS400 power/interface cable at the office, but I probably won't be back there until roughly 7/4. Slammed wi...

5 years ago
Reply
RE: Trying to drive Ray Marine EV100 AP with a Garmin EchoMap SV plotter

Nav data such as XTE and Wpt Rng/Brng has defined PGN's that will transmit across N2 between brands, but there are no such standardized PGN's for pilo...

5 years ago
Reply
RE: Simrad AIS 400 PWR/0183 connector

Let me know if you are still looking for a cable for the NAIS400. I likely have one.

5 years ago
Reply
RE: Simrad Autopilot Head Units to replace AP11?

The AP22 and the AP21 will also work with your J3000X CPU.

5 years ago
Reply
RE: Getting Two B&G Zeus MFD's to Share Charts

Well, there kinda is a larger and faster NEP device. The NEP is nothing more than a marinized Ethernet switch. And it's got a bit of a tubbish chass...

5 years ago
Reply
RE: Garmin VHF AIS confusion

Ben - the new AIS800 does have a splitter built in to the chassis, just as the AIS600 did/does. I have one sitting on my desk right in front of me....

5 years ago
Reply
RE: Getting Two B&G Zeus MFD's to Share Charts

Doug - main issue has been general instability. As a rule we don't run other network items through a WiFi1. In most situations if we are onboard a ...

6 years ago
Reply
RE: Getting Two B&G Zeus MFD's to Share Charts

It is not mentioned if by any chance one of the MFD's Ethernet is cabled through a Wifi1 GoFree device. Some installers do this as it looks like it i...

6 years ago