Welcome to the Panbo Marine Technology Forums.
Last seen: September 28, 2024 10:37 am
Interesting purchase for them. They have a lot of products that could be installed on that fleet of boats. We have 4-6 of the Freedom Boats at our mar...
A few ways I could think of doing this: SignalK - you could use a Raspberry Pi and install SignalK on it, use the Vesper as the SignalK data source, a...
I've had this conversation with many folks I've worked with on consulting opportunities, or just in passing. Yes, you can network some of the more fri...
Yup I saw something similar on TF I believe 🙂 Hi there. You'll still need the USB to MasterVolt interface and the software downloaded on a Windows P...
If you have CZone enabled devices, and in particular, digital switching on the MasterVolt side, then using the CZone bridge would be the best route to...
I have only used the GX6000 for a few hours on another boat and have not owned one. I believe one of the Bens either has one or had access to one for ...
Hi Patrick, I just went through a similar search for my new boat. I had a Standard Horizon 2150 at the flybridge, and a really old Standard Horizon T...
I have never really found a perfect mount, but what I have been using on a few installs is a short antenna extension from Shakespeare. I can run the E...
Hi Geoff, Depending on how you setup your Groove, it would work as you outlined. If you setup your Groove in router mode, which I recommend in my fol...
I've used a couple of MoFi products, and they are pretty nice, but their UI is a mess. If you're going to have your customer use it, and they are not ...
I'm in the same situation. New boat, older XB-8000 I took out of storage and put on board which does not really work well in busy Seattle waters. I ma...
The GMI-20 can display engine data in a couple of ways from what I remember. It has dedicated engine display screens like the one I've attached but ap...
I've used most of them as well, and Ben's comments are exactly what I'd say. Somewhat slower, definitely lower resolution, and concerns in general abo...
I have been a user of Coastal Explorer since the original version, OpenCPN for a long time as well, and also TimeZero off and on through the years. Co...
Good point on the adapter, Ben. Personally, I just purchase the blue SeaTalkNG backbone cable, chop one end off, and put a Maretron end on and continu...
